.. TODO: create message listing from EnumStatusRegister.m, see GEN2-4192

.. _messages:

Status Messages
---------------

The |product_type| has various messages, which elaborate on the product's present :ref:`status <statuses>`. A message may indicate normal operation, power limiting as a result of the |product_type|'s operating profile, or steps to resolve a fault.


**Messages for Status: Enabled**

* Input enabled.
* Product is operating below its minimum voltage rating. Increase the input voltage to proceed.
* Exceeded MOSFET power rating.
  

**Messages for Status: Disabled**

* Input disabled.


**Messages for Status: Soft Fault**

* Voltage exceeded the trip point. Press CLEAR to resume.
* Voltage has fallen below the trip point. Press CLEAR to resume.
* Current exceeded the trip point. Press CLEAR to resume.
* Power exceeded the trip point. Press CLEAR to resume.
* Remote sense loss. Only 10 percent compensation is allowed. Press CLEAR to resume.
* Global shutdown occurred.


**Messages for Status: Hard Fault**

* Global shutdown occurred.
* Chopper stage currents have exceeded product rating. Verify load does not exceed product ratings.
* Excessive communication errors detected. Check cabling and addressing resistors. Call technical support.
* Product has exceeded its voltage rating. Investigate the cause before retrying.
* Product has exceeded its current rating. Investigate the cause before retrying.
* The internal power supply has blown a fuse. Contact Magna-Power for support.
* Analog or Digital input voltage exceeded the max voltage specified. Investigate the cause before trying again.
* One of the AC Input Phase is missing. Investigate the cause before retrying.
* One or more fan has stopped spinning. Investigate the cause before retrying.
* Linear modules have exceeded their temperature rating. Check for ventilation blockages and the ambient temperature.