3.2. Menu System Listing

Trip-Point Settings
- OVT - Sets the over voltage trip set-point
- OCT - Sets the over current trip set-point
- OPT - Sets the over power trip set-point
- UVT - Sets the under voltage trip set-point
Control Mode
- Standby
- Auto Crossover
- CalLoad1
- CalLoad2
Function Generator
- Function Type
  - Sinusoid
  - Square
  - Step
  - Ramp
- Function Parameter
  - Sinusoid Parameters
    - Amplitude
    - Offset
    - Period
  - Square Parameters
    - LoLevel
    - HiLevel
    - LoPeriod
    - HiPeriod
  - Step Parameters
    - LoLevel
    - HiLevel
  - Ramp Parameters
    - LoLevel
    - HiLevel
    - RiseTime
    - FallTime
Function Generator
Communication Setting
- RS485
  - RS485 Information
- Command Protocol
  - SCPI
  - MagnaLINK
  - Modbus
  - Anybus
- Ethernet Settings
  - MAC Address
Performance Settings
- Slew Rates
  - Rise - Voltage Slew (V/ms)
  - Fall - Voltage Slew (V/ms)
  - Rise - Current Slew (A/ms)
  - Fall - Current Slew (A/ms)
  - Rise - Power Slew (W/ms)
  - Fall - Power Slew (W/ms)
- Remote Sense Mode
  - Local
  - Remote
System Settings
- Setpoint Source
  - Front Panel
  - Function Generator
  - Analog Input
  - Sequence Input
- Analog Digital IO
  - Analog Input Pins
    - Pin 5
    - Pin 17
    - Pin 18
  - H/S Analog Input Pin
    - Pin 6
  - Analog Output Pins
    - Pin 3
    - Pin 4
    - Pin 15
    - Pin 16
  - Digital Input Pins
    - Pin 11
    - Pin 12
    - Pin 23
    - Pin 24
  - Digital Output Pins
    - Pin 7
    - Pin 8
    - Pin 9
    - Pin 10
    - Pin 19
    - Pin 20
    - Pin 21
    - Pin 22
- Fan Speed
  - Variable
  - Max
  - Off
- Factory Restore
  - Cancel
  - Soft Restore
  - Hard Restore
About
- Unit Description
- Sys Power (kW)
- Sys Volt (V)
- Sys Curr (A)
- Serial
- Address
- Firmware Vers
- Bootloader Vers
- Hardware Vers
- Internal Slaves
- External Slaves