Table of Contents

Getting Started

• 1. Preface
  • 1.1. Contact Magna-Power
  • 1.2. Safety Notice
  • 1.3. Safety Symbols
  • 1.4. Limited Warranty
  • 1.5. User Manual Warranty
  • 1.6. U.S. Government Rights
  • 1.7. WEEE Directive 2002/96/EC
  • 1.8. Declaration of Conformity
  • 1.9. Document Conventions
  • 1.10. Additional Help and Feedback
• 2. Product Information
  • 2.1. Product Introduction
  • 2.2. Features at a Glance
  • 2.3. Key Features
  • 2.4. Models
  • 2.5. Specifications
  • 2.6. Dimensional Diagrams
  • 2.7. Principle of Operation
  • 2.8. Options
  • 2.9. Accessories
• 3. Installation
  • 3.1. Inspection
  • 3.2. Package Contents
  • 3.3. Rack Installation
  • 3.4. AC Input Connection
  • 3.5. DC Output Connection
  • 3.6. Protective Covers
  • 3.7. Remote Sense Connection
  • 3.8. Water Cooling
  • 3.9. Electrical Check

Operation

• 1. Features and Functions
  • 1.1. Output Regulation States
  • 1.2. Commands
  • 1.3. Protection and Diagnostics
• 2. Operation: Front Panel
• 3. Setting Set Points
  • 3.1. Voltage
  • 3.2. Current
  • 3.3. Period
• 4. Setting Trip Points
  • 4.1. Over Voltage Trip
  • 4.2. Over Current Trip
• 5. Configuring Set Point Source
  • 5.1. Rotary (ROTARY)
  • 5.2. Keypad (KEYPAD)
  • 5.3. External Program (EXT PGM)
  • 5.4. Remote (REMOTE)
• 6. Configuring Functionality
  • 6.1. Remote Sense (REM SEN)
  • 6.2. Internal Control (INT CTL)
  • 6.3. External Control (EXT CTL)
  • 6.4. Interlock (LOC)
• 7. Calibration
• 8. External User I/O
  • 8.1. Analog Inputs
  • 8.2. Analog Outputs
  • 8.3. Digital Inputs
  • 8.4. Digital Outputs
  • 8.5. Reference Signals and Grounds
• 9. Parallel and Series
  • 9.1. Parallel
  • 9.2. Series
• 10. Operation: Computer Programming
  • 10.1. Introduction
  • 10.2. RS232 Communications
  • 10.3. LXI TCP/IP Ethernet Communications
  • 10.4. RIS Panel
  • 10.5. IEEE-488 GPIB Communications
• 11. Calibration
  • 11.1. Control Board
  • 11.2. Driver Board

Programming

• 1. SCPI Programming
  • 1.1. SCPI Command Set
  • 1.2. CALibration Subsystem
  • 1.3. CONFigure Subsystem
  • 1.4. MEASure Subsystem
  • 1.5. MODulation Subsystem
  • 1.6. OUTPut Subsystem
  • 1.7. SOURce Subsystem
  • 1.8. STATus Subsystem
  • 1.9. SYSTem Subsystem
  • 1.10. TRIGger Subsystem
  • 1.11. Restricted Command Set