4.7.11. Target Diagnostics

The ALx Series incorporates Target Diagnostics, a six-LED matrix on the rear panel that mirrors the status indicators located on each major internal assembly. The Target Diagnostic LEDs are readable with the unit rack-mounted and with the covers attached. Target Diagnostic LEDs correspond to the internal assemblies listed in Target Diagnostics LED-to-Assembly Map. Each LED flashes the Morse Code dot/dash pattern shown in LED Morse Code patterns and descriptions to report the assembly’s state (heartbeat, configuration notice, or fault).

Fig. 4.18 Target diagnostics LED matrix on the rear of the product

When combined with the MagnaCTRL EPROM Editor, Target Diagnostics enables off-site personnel to interpret codes and issue corrective actions, reducing mean time to repair. Typical end-users will not reference these codes during normal operation; they are intended for Magna-Power service teams or qualified technicians.

Table 4.2 Target Diagnostics LED-to-Assembly Map

LED Number	Address	Internal Assembly
1	41	Front Panel
2	45	Aux Power
3	9	Gate Driver
4	1	Main Controller
5	N/A	Reserved
6	N/A	Reserved

Table 4.3 LED Morse Code patterns and descriptions

Letter	Morse Code	Description
A	· −	[A]ctive control
B	− · · ·	[B]oot Failure
C	− · − ·	[C]heck Firmware
D	− · ·	[D]etect Master Slave
E	·	[E]mpty/Corrupt External Flash
F	· · − ·	[F]ault
G	− − ·	[G]lobal Shutdown Detected
H	· · · ·	[H]
I	· ·	[I]ndependent Standalone Role
J	· − − −	[J]
K	− · −	[K]
L	· − · ·	[L]oad EEPROM
M	− −	[M]aster Role
N	− ·	[N] Calibrate HR Capture
O	− − −	C[o]mmunications Error on Firmware Upgrade
P	· − − ·	[P]rogramming Flash
Q	− − · −	[Q]
R	· − ·	[R]eset Waiting for Initialization
S	· · ·	[S]tandby/[S]lave Role
T	−	[T]arget Ready Waiting State
U	· · −	[U]
V	· · · −	[V]
W	· − −	[W]riting Ext. Flash
X	− · · −	E[x]ternal Flash read/corruption failure
Y	− · − −	[Y]
Z	− − · ·	[Z]